This document outlines the specifications for the HX TYPE-C 14P LT H10.0 connector manufactured by Shenzhen Hanxia Electronic Co., Ltd. It details the product's electrical, mechanical, and durability characteristics, along with standard testing conditions.
| Item | Test Conditions | Performance Specification |
| Mechanical Properties | ||
| Connection Force | Measurement after connecting and disconnecting using standard plug gauge 3 times. | 0.5-2.0 Kgf |
| Disconnection Force | Measurement after connecting and disconnecting using standard plug gauge 3 times. | 0.6-2.0 Kgf |
| Terminal Strength | A static load of 0.1N/m (1kgf/cm) applied to the tip of the terminal for 1 min in any direction. No damage to the terminal such as cracks, looseness or play. Electrical and mechanical characteristics shall be satisfied. | N/A |
| Electrical Properties | ||
| Contact Resistance | Measured at small current (100mA or less) at 1000Hz. | 30m MAX |
| Insulation Resistance | Apply a voltage of 100V DC for 1 min to specified portions. | 100M MIN |
| Dielectric Strength | AC 100V (50Hz)/min voltage for 1 minute, sensitivity current 0.5mA. Tested between specified portions. No insulation breakdown. | 100VAC ims (50~60Hz) for 1 min, Trip current: 0.5mA |
| Durability | ||
| Solderability Test | Top of terminals dipped 1mm in solder bath of 2505 for 50.5 seconds. | Solder wetting time 3 sec. Soldering area > 75%. |
| Resistance to Soldering Heat Test (Reflow) | Preheat: 180 for 120s. Peak temperature: 2605 within 20 seconds. | No deformation of case or excessive looseness of terminals. Electrical characteristics shall be satisfied. |
| Resistance to Soldering Heat Test (Soldering Iron) | Bit temperature 3305, application time 30.5 seconds. No excessive pressure on terminals. | No deformation of case or excessive looseness of terminals. Electrical characteristics shall be satisfied. |
| Humidity Test | Stored at 402 and 90%-96% humidity for 96 hours, then maintained at standard atmospheric conditions for 1 hour. | N/A |
| Heat Test | Stored at 702 for 96 hours, then subjected to controlled recovery for 1 hour. | No damage on appearance. Mechanical and electrical characteristics shall be satisfied. |
| Cold Test | Stored at -253 for 96 hours, then subjected to controlled recovery for 1 hour. | No damage on appearance. Mechanical and electrical characteristics shall be satisfied. |
| Life Test (Without Load) | Connection and disconnection for 10000 cycles at a speed of 10 to 25 cycles/min. | N/A |
| Life Test (With Load) | At rating condition (non-inductive load), connection and disconnection for 10000 cycles at a speed of 10 to 20 cycles/min. | Contact Resistance 0.1. Disconnection Force 0.8 to 2.0N. Mechanical and electrical characteristics shall be satisfied. |
| Temperature Cycling Test | 5 cycles of specified conditions, then allowed to remain in room ambient for 30 minutes. | No deformation or cracks in molded part. Insertion & Extraction Force: 3 to 20N. Contact Resistance: Max.30m. Insulation Resistance: Min.100 M. Dielectric Withstanding Voltage: 100VAC/min (between terminals). |
| Cold & Heat Shock Test | 5 cycles of specified conditions, then allowed to remain in room ambient for 30 minutes. | No deformation or cracks in molded part. Insertion & Extraction Force: 3 to 25N. Contact Resistance: Max.30m. Insulation Resistance: Min.100 M. Dielectric Withstanding Voltage: 500VAC/min (between terminals). |
