This document outlines the electrical and environmental performance specifications for the HS45E product from HAOYU (HONG KONG) LIMITED, adhering to various EIA and MIL-STD test methods.
| Item | Description | Test Methods | Test Specification |
|---|---|---|---|
| 7.1 | Insulation Resistance | EIA 364-21C | 100M minimum (unmated) between adjacent contacts and contacts and shell/ground. Apply 100Volts DC. |
| 7.2 | Low Level Contact Resistance | EIA 364-23b | 40m (Max) initial for VBUS and GND contacts; 10m (Max) initial for all other contacts. Delta 10m (Max) after test. 20mV Max. open circuit at 100mA. |
| 7.3 | Dielectric Withstanding Voltage | EIA 364-20 | There shall be no breakdown when subjected to 100VAC (RMS) for 1 minute between adjacent terminals. |
| 7.4 | Contact Current Rating | EIA364-70 | 5.0A applied collectively to VBUS pins, 1.25A to VCONN pin, and 0.25A to other contacts. Temperature rise shall not exceed 30C. |
| 3.x | Durability | EIA 364-09 | 10000 cycles. Must meet contact resistance (delta 10m Max), insertion force (5N-20N), extraction force (8N-20N), and visual inspection criteria. |
| 3.x | Cable Flexing | EIA 364-41 | 100 cycles in 2 planes at 120 degrees. No discontinuity over 1 microsecond or physical damage. |
| 3.x | Cable Pull-Out | EIA-364-38 | 40N steady state axial load for 1 minute. No discontinuity or physical damage. |
| 3.x | 4-axes continuity test | EIA364-18 | 8N tensile force for 10 seconds in 0, 90, 180, 270 directions. No discontinuity > 1s or physical damage. |
| 8.1 | Temperature Life | EIA 364-17 | 105C without applied voltage for 120 hours. Also 72 hours for preconditioning. Visual inspection required. |
| 8.2 | Thermal Shock | EIA 364-32 | 10 Cycles -55C and +85C. Mated connectors. No evidence of physical damage. |
| 8.3 | Salt Spray | MIL-STD-202F, Method 101D, Condition B | 48 hours at 35C with 5% Salt-solution. Shall meet visual requirements and show no physical damage. |
| 8.4 | Humidity | EIA 364-31 | 90% RH @ 25C for 24 hours, then 95% RH @ 65C for 24 hours. Shall meet visual requirements and additional tests as specified. |
