This document outlines the performance and mechanical requirements for the SHENZHEN JUSHUO ELECTRONICS CO., LTD USB Type-C connector.
SHENZHEN JUSHUO ELECTRONICS CO., LTD
China
| Item | Requirements | Test Methods | Test Reference Standard |
|---|---|---|---|
| Confirmation of Product | Shall be conforming to the requirements of applicable product drawing. | Visually inspected per applicable product drawing. | |
| Low level Contact resistance | 1. 40 m (Max) initial for VBUS, GND and all other contacts. 2. Maximum change (delta) of +10 m after environmental stresses. Measured at 20mV Max. open circuit at 100mA. | The low level contact resistance measurement is made from the solder tail of the receptacle to the soldering point of the plug. Mated test contacts must be in a connector housing. | EIA-364-23B |
| Insulation Resistance | 100 M Min. | Test between adjacent circuits of unmated and mated connectors. | EIA 364-21 |
| Dielectric Strength | No breakdown shall occur. | 100 Volts AC (RMS) is applied between adjacent contacts of unmated and mated connectors. | EIA-364-20 |
| Contact current rating (VBUS pins) | 3.0 A | Applied collectively to VBUS pins (A4, A9, B4, and B9). | EIA -364-70 method B |
| Contact current rating (VCONN pin) | 1.25 A | Applied to the VCONN pin (B35) with return path through GND pins (A1, A12, B1, and B12). | EIA -364-70 method B |
| Contact current rating (Other contacts) | 0.25 A | Applied individually to all other contacts. | EIA -364-70 method B |
| Temperature Rise | Shall not exceed 30 C | Measured at any point on the USB Type-C mated plug and receptacle under test, when ambient temperature is 25 C. | EIA 364-70 J7:B |
| Insertion Force | 0.5~2.0 kgf | Measure the force required to mate connector, at a maximum rate of 12.5mm/minute. | EIA-364-13 |
| Extraction Force | 0.8~2.0 kgf | Measure the force required to mate connector, at a maximum rate of 12.5mm/minute. | EIA-364-13 |
| Durability (Cycles) | 10,000 cycles | Durability test shall be done at a maximum rate of 200 cycles per Hour. No physical damage to any part of the connector and cable assembly shall occur. | EIA-364-09 |
