Product Type: DIN Signal male connector
Design Standards: EC 60603-2 types: B, 2B, C, 2C, 3C male
Contact Spacing: 2.54mm
Termination Technology: Solder pins
Insulator Material: PBT [thermoplastics, glass fiber reinforcement 30%] (Material group acc. to IEC 60664-1: IIa {75C})
Insulator Color: RAL 7032 [grey]
Contact Material: Copper alloy
Plating Termination Zone: Sn over Ni
Soldering Instructions: Connectors should be protected during soldering to prevent contamination or deformation due to heat. For prototypes and short runs, use industrial adhesive tape. For large series, a jig with a protective cover is recommended.
| Max. Contacts (n) | Test Voltage (V) | Contact Resistance (max. ) | Insulation Resistance (min. ) | Working Current (max. A) | Temperature Range (C) | Insertion/Withdrawal Force (max. N) | Clearance & Creepage Distance (min. mm) | Mating Cycles (Performance Level) |
|---|---|---|---|---|---|---|---|---|
| (various) | 1000 | 20 | 10^9 | 2 at 20C | -55 to +125 | (see below) | 1.2 | (see below) |
| Number of Contacts | Insertion/Withdrawal Force (max. N) |
|---|---|
| 2 | 6 |
| 3 | 30 |
| 6 | 15 |
| 9 | 90 |
| 20 | 20 |
| 30 | 30 |
| 48 | 45 |
| Performance Level | Mating Cycles | Plating Contact Zone (min. m) | Plating Contact Zone |
|---|---|---|---|
| 1 | 500 | 7.6 (30inch) | Au over PdNi over Ni |
| 2 | 400 | 7.6 (30inch) | Au over PdNi over Ni |
| 3 | 50 | 7.6 (30inch) | Au over PdNi over Ni |
| NM30 (S4) | 500 | 0.76 (30inch) | Noble metal (alloy) over Ni |
| Au30 | 500 | 0.76 (30inch) | Au over Ni |
| Au50 | 500 | 1.27 (50inch) | Au over Ni |
| Au71 | 500 | 1.60 (70inch) | Au over Ni |
| Au90 | 500 | 2.00 (90inch) | Au over Ni |
| Derating Diagram | Description |
|---|---|
| IEC 60512-5 (Current carrying capacity) | Current carrying capacity is limited by the maximum temperature of materials for inserts and contacts, including terminals. The curve is valid for continuous, non-interrupted current loaded contacts when simultaneous power on all contacts is given, without exceeding the maximum temperature. Control and test procedures according to DIN IEC 0512-5 . |
